Original Hugen Version TinySA 2.8 inch Display 100kHz to 960MHz Hand held Tiny Spectrum Analyzer with ESD Proteced
$77.99
In stock
User interface:
* Display resolution 320*240 pixels
* Screen diagonal 2.8"
* 16 bits per RGB pixels
* Resistive touch control
* Jog switch control
* USB serial port control
* Optional TTL USART port (SW not yet implemented) on the internal PCB
* Linear power supply to avoid switching noise.
*Add port ESD protection to upgrade version（V0.3.1_E）
The input/output specification of the tinySA is split over the 4 modes
Low input mode spec:
* Input frequency range from 100kHz to 350MHz
* Input impedance 50 ohm when input attenuation set to 10dB or more.
* Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps
* Absolute maximum input level without attenuation of +10dBm
* Absolute maximum input power with 30dB attenuation of +20dBm for short period
* Input Intercept Point of third order modulation products (IIP3) with 0dB attenuation of +15dBm
* 1dB compression point at +2dBm with 0dB attenuation
* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB
* Absolute power level accuracy after power level calibration of +/- 1dB
* Lowest discernible signal using a resolution bandwidth of 30kHz of -102dBm
* Frequency accuracy equal to the selected resolution bandwidth
* Phase noise of -90dB/Hz at 100kHz offset and -115dB/Hz at 1MHz offset
* Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB
* Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.
* On screen resolution of 145 or 290 measurement points.
* Scanning speed of over 1000 points/second using largest resolution filters.
* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth
* Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal
* Input frequency range from 240MHz to 960MHz
* As there is no input bandfilter strong signals outside the 240MHz to 960MHz range can cause distortion of the in band signals
* Absolute maximum input level without attenuation of +10dBm
* Input Intercept Point of third order modulation products (IIP3) of -5dBm
* 1dB compression point at -6dBm with 0dB attenuation
* Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB
* Absolute power level accuracy after power level calibration of +/- 1dB
* Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm
* Frequency accuracy equal to the selected resolution bandwidth
* Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB
* Selectable (automatic and manual) resolution filters of 3, 10, 30, 100, 300 and 600kHz
* Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +/- 15dB
* On screen resolution of 145 or 290 measurement points.
* Scanning speed of over 1000 points/second using largest resolution filters.
* Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth
* Sinus output with harmonics below -40dB of fundamental
* Output frequency range from 100kHz to 350MHz
* Output level selectable in 1dB steps between -76dBm and -6dBm
* Optional AM, narrow FM and wide FM modulation or slow sweep over selectable frequency span
* Square wave output
* Output frequency range from 240MHz to 960MHz
* Output level selectable in variable increments between -38dBm and +13dBm
* Optional narrow FM and wide FM modulation or slow sweep over selectable frequency span
* Optional square wave output with fundamental at -25dBm connected to high input/output
* Frequency can be set to 1MHz, 2MHz, 4MHz, 10MHz, 15MHz or 30MHz.
* Charging time max 1 hour on 500mA minimum USB port or USB charger
* Operation on fully charged battery for at least 2 hours
TinySA 2.8" Spectrum analyzer *1
20cm sma-sma rg174 rf cabe *2
USB Type-C Data Cable *1
Hand rope *1
SMA female to female connector *1
SMA telescopic antenna *1
| Weight | 0.248 lbs |
|---|---|
| Dimensions | 22 × 19 × 4 in |
| Brand Name | TOOLTOP |
| High-concerned chemical | None |
| DIY Supplies | Electrical |
| Origin | |
| Battery Included | Yes, No |
| Choice | yes |
10 reviews for Original Hugen Version TinySA 2.8 inch Display 100kHz to 960MHz Hand held Tiny Spectrum Analyzer with ESD Proteced
MAECENAS IACULIS
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
ADIPISCING CONVALLIS BULUM
- Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
- Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
- Diam parturient dictumst parturient scelerisque nibh lectus.
Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.
Related products
J***l –
If the product is not tested, it is as described, very well packaged.
Color: Tinysa 2.8 inch
C***L –
Great product and very good value for money.
Color: Tinysa 2.8 inch
Z***4 –
The tinysa while not the ultra version, it is highly functional and probably the best choice for starters and at a very significant price point, the device ensures quality and i have already realized multiple tests and calibration and so far it has meet all of my demands, the device is equipped with multiple units of measurent, such as dbm, watt, dbv, and multiple functions to help you analyze frequencies, while it has a listen function, this product doesn’t come with the speaker, so you’ll have to add one, however it is amazing in it’s standard functions, all you need to do is calibrate it and set the input level to -25 db, and you’ll have it fully functional and ready for testing.
The product also comes with an antena for receiving, two coxial cables and a sma f-f adapter, it also comes with a screen contact pick, which you can use if you don’t have a screen pen, and overall the build quality is very decent, advice from the manufacturer tho is to avoid esd discharges on it.
Color: Tinysa 2.8 inch
L***i –
Working original, works as it should, calibration and self-test pass, so ori!
Color: Tinysa 2.8 inch
c***r –
Works well, ideal for my needs. Perfect for finding out which of my radios are broadcasting spurious emissions.
Color: Tinysa 2.8 inch
Anonymous –
Fast delivery. Solid packaging. After charging the battery, some functions were tested. The keys achieved good results.
Thank you and happy to shop with this seller again.
Color: Tinysa 2.8 inch
V***s –
Using to find most free frequency for wireless microphones and in ear monitors. For such purpose this device is great! Small, light, easy to use and price also is great.
Color: Tinysa 2.8 inch
M***i –
For amateur use at this price, it can be recommended; for my needs, it works 100%.
Color: Tinysa 2.8 inch
i***A –
Color: Tinysa 2.8 inch
Anonymous –
Color: Tinysa 2.8 inch